Virtual multi-split

[Patate le mage]

It would be very useful for me if copperlan manager allow me to make virtual multi-split of my keyboard.
I explain if it's not clear :
I use AL 88-c.
I have a Keyboard midi out into midi in 1 of AL 88-c.
If it was possible on copperlan manager i could, for example :
Point C2-B3 from my keyboard to midi out 2 on al-88 C
Point C3-B5 from my keyboard to Alyseum AL 812 Mono out 1
Point C6-B7 from my keyboard to Midi out5 and Midi out 6 on AL 88-C

And that for all the keyboards i use.

Thank you.

[Copperhead]

It would be very useful for me if copperlan manager allow me to make virtual multi-split of my keyboard.

I think there is a basic misunderstanding in the role of the CopperLan Manager here.
If you had multiple AL-88 or any other CopperLan hardware products connected together, you would be able to disconnect the computer after having established the connections.

A CopperLan setup does not need a computer for the connections to work because the flows are not matrixed by the CopperLan Manager, they are flowing directly between the various units involved.

Therefore, the key zone splitting you ask for should be done by the interface in charge of the MIDI flows.
Your request is for the manufacturer of those interfaces

[Patate le mage]

Thank you for the answer.

In fact you are right, i had never used the copperlan with a computer disconnect.

I have to think about that, it's not very simple.......